The Draw Tite Hitch part # 75776 that you referenced would not fit your 2009 Hyundai Santa Fe. The design of the hitch is very different from what is confirmed to fit your vehicle so it would not work for you.
For a hitch for you vehicle I would recommend the Draw-Tite part # 75471, only thing is that it is not rated for weight distribution. It does have a 3,500 lb trailer capacity and a 525 lb tongue weight capacity.
For trailer wiring you would want the Tow Ready wiring harness part... view full answer...
There are Class II and Class III hitches available for your Santa Fe Sport. Because the Class III uses the more common 2 inch receiver opening, which would give you many more flexibility in choosing hitch mounted accessories such as cargo carriers or bike racks.
I'd recommend the Draw-Tite Class III hitch, part # 75772 as it is the most reasonably priced. All the available hitches would be just as visible from the rear, so none would have an advantage there. Although this hitch is the... view full answer...
The etrailer carrier part # e98874 is made from steel and is powdercoated so it's not going to have any issues with heat from exhaust. The carrier has 2 inches of rise built into the shank too so it most likely would carry the bag you mentioned part # C18211 high enough that the exhaust would not be an issue for that as well. view full answer...
Yes we do have a hitch for the 2017 Hyundai Santa Fe Limited. The Curt hitch part # C13153 is confirmed as a fit and would be an excellent choice. I attached an install video for you to check out as well.
If you wanted to do some towing you might be interested in etrailer ball mount kit # 989900. It comes with 2 ball mounts; one with a 3/4 inch rise or 2 inch drop and one with a 2-3/4 inch rise or 4 inch drop. It also includes a 1-7/8 inch ball, 2 inch ball, hitch pin with clip, and a... view full answer...
For your 2017 Hyundai Santa Fe, you can get a factory roof rack and carry a rooftop cargo carrier without issue. The aftermarket roof racks can give you more diversity for other uses. If you go this route, I recommend the Rhino-Rack roof rack consisting of the Rhino-Rack Vortex Aero Crossbars - Aluminum - Black - 54" Long - Qty 2 # RRVA137B-2 and the Rhino-Rack SRB Legs for Vortex Aero Crossbars - Flush Factory Side Rails - Qty 4 # RRSX032. This system gives you aero crossbars that are... view full answer...
When we installed the Curt hitch # C13073 on a 2011 Hyundai Santa Fe we found that there was 4-1/2 inches from the center of the hitch pin hole to the rear edge of the rear bumper. view full answer...
What you would need to do is have the weld-on sway bar tab part # 3442 attached to the driver side of the ball mount # C45036 that you have so that you can use the sway control you have that's set up to be used on the driver side. view full answer...
The Curt Class III hitch part # C13152 that you referenced would be a great choice for a hitch for your 2015 Hyundai Santa Fe Sport to carry a bike rack as it has been confirmed as a fit, has more than enough capacity, is our most popular option, and has the best price.
Our most popular bike rack that is similar to this one is the Swagman XC part # S64650. I can guarantee this rack will fit and work great without any issues at all. view full answer...
With a hitch installed like the Curt part # C13153 you'd have the ability to use a weight distribution system like you are interested in but you need to determine the weight of your trailer when loaded and make sure it's also under the towing capacity of your vehicle to be certain. The overall towing capacity of a vehicle is the lowest rated component in the setup. The Curt hitch I mentioned would easily be able to tow a 5,000 lb trailer if needed but you need to make sure you are under... view full answer...
Curt offers a hitch that fits your 2016 Hyundai Santa Fe Limited with the # C13153 but the # C13900 that you referenced does not fit your vehicle. view full answer...
The Draw-Tite Max-Frame Trailer Hitch Receiver # 75471 is a confirmed fit and an excellent choice for your 2009 Hyundai Santa Fe. It does not come with a ball mount or with wiring for trailer connection.
For your trailer wiring, I recommend the T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # 118415. This harness installs to your factory harness located behind the driver's-side and passenger's-side interior trim panels in your rear cargo area.
Then for an adjustable... view full answer...
I would be happy to help!
Starting with the 7-way connector the # ETBC7 is the correct option for your 2017 Hyundai Santa Fe. This will plug into your existing 4-way connector and only require a few more connections. The black wire will get run to the positive terminal of your battery with the included 40 amp circuit breaker, the white wire will get grounded to the frame of your vehicle, and the blue wire will get run underneath the dash of your vehicle where you are planning on installing... view full answer...
It realistically is going to have the port for the Curt # C56332 but you should still check. We have had several customers come back and say their Santa Fe did not have the tow package but the connectors were present. view full answer...
There would be no benefit to purchasing a 3-bike trunk mounted bike rack unless you were actually wanting to carry three bikes. You wouldn't gain any stability by going with the 3 bike version of the Thule passage trunk mount bike rack.
For two bikes, use the # TH910XT Passage model. view full answer...
The LMX Red Grease like part # L11390 is the best overall grease for boat trailer applications like you mentioned. It's just as waterproof as any marine grease but is also more heavy duty so it's the way to go for sure. view full answer...
On your 2017 Hyundai Santa Fe, we carry both the Draw-Tite Class III Hitch, # 75776, and the Curt Class III Hitch, # C13153. Both hitches are designed to be custom-fit for your the 2017 Santa Fe. Both are welded hitches that are designed to install with no drilling to the frame required.
I recommend the Curt hitch over the Draw-Tite hitch for your Hyundai. The Curt hitch has a higher towing capacity and on average a shorter installation time.
If your vehicle has OEM connection towing... view full answer...
We have a way to order a Thule aero bar roof rack for your 2020 Hyundai Santa Fe with flush bars with longer than 47 inch bars but we can't guarantee that the bars will fit reason being the track that is on the underside of the bar that attaches to the feet does not run the entire length of the bar.
So normally you'd want the bars # TH711220, # TH460R, and # THKIT4093 but for a longer bar you'd want the # TH711320 for a 50 bar instead. There's a pretty solid chance the 50 inch bar will... view full answer...
The SumoSprings Coil Springs kit part # CSS-1145R is a fit for your 2018 Hyundai Santa Fe XL. There aren't any air bag options that fit your vehicle either. This is the only option. view full answer...
According to the fine folks at Yakima, the HangOut 3 bike rack you is a fit for your 2011 Hyundai Santa Fe. If your Santa Fe is equipped with a rear windshield wiper, make sure you do not use it when the rack is installed. The rack has a 90 lb capacity when used with three bikes.
For easy install and removal, the Thule OutWay, part # TH45JV might be a better choice. Instead of the clumsy strap and buckle attachment method used by other racks, the Raceway uses only 2 rubber-coated straps... view full answer...
In order to determine which trailer wiring harness you'll need, look under the vehicle just to the rear of the rear wheel on the driver's side of the vehicle. If you see the two connectors shown in the provided photo, use the Curt # C56332 connector. If the connectors under the vehicle on the driver's side aren't present, you'd use the Curt # C56184.
If you click the provided links, you can see the installation instructions for each wiring harness as well as an install video for each one. view full answer...
Go To Results